http://www.casablancacar.com/3000-watt-power-amp/
Thanks for visiting Casablanca Car your source for 3000 Watt Power Amp !We hope you will find the
3000 Watt Power Amp information that you seek.
 |
 Xantrex RV 3012GS Inverter  US $1,000.00
|
 MTX Car Audio 2 12 Car Subwoofers Amplifier Sub Box US $204.99
|
 1500W PURE SINE WAVE POWER INVERTER 12DC110AC POWERJACK US $199.97
|
 3000 Watt Modified Sine Inverter US $76.00
|
 HIFONICS HFI3000D Monoblock Amplifier 3000W RMS Car Amp US $269.99
|
 Xantrex Statpower XPower Powerpack 1500 802 1500 US $525.46
|
 Kicker PKD1 Wire Kit US $60.00
|
 NEW SOUNDSTORM EV4000D 4000W MONO D Car Audio Amplifier Power Amp MOSFET US $122.95
|
 Pyle Dryver PLAD413 Car Amplifier Lots of Watts 2000Watts US $129.95
|
 Xantrex RV2012GS Inverter Charger US $700.00
|
 XANTREX FLEET POWER FP 1000 12 HDT INVERTER CHARGER US $550.00
|
 XANTREX RV 3012GS INVERTER US $950.00
|
 PLANET AUDIO BB24001 3000W MONO D Car Power Amplifier US $289.99
|
| Powered by phpBay Pro |
Car Audio: Pairing an amp to a sub.?
How many watts should I run through a single Pyle sub (3200 peak power)? would a 3000 watt amp be okay?
I am set on picking up a PLD12WD which runs 3200 peak power. Im not sure of the RMS rating though. Would it be okay to run a Pyle PLA2230 through it bridged? It is a 3000 watt Amplifier.
Is there a different set up I should use?
If you are set on buying that sub and want a pyle amp then this amp would be a better match.
http://www.amazon.com/Pyle-PLAD3300D-3600-Watt-Digital-Amplifier/dp/B0007L8AL8
Being that sub is a 4ohm DVC you would need to wire it in parallel for a 2ohm load.
See here how to wire your sub and use option 1.
http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=42
And with your sub wired to a 2ohm load you can't bridge it to that 2 channel amp you was talking about,because it won't handle an ohm load that low when bridged.
